Sistema de Gestão de Rede

Solicito apoio técnico para verificação de alarme no ACCID Dados (Circuito): "N/A" com a falha de "Tipo de Falha: Link Down". O circuito começa em (Roteador A (Origem): RNAGRJO-RJME04-01-1/1/6. Status: UP, Fabricante: CISCO, Alarme Ativo: LATENCIA ALTA) indo ate (Roteador B (Destino): RNACRJO-RJME26-01-1/1/17. Status: UP, Fabricante: CISCO, Alarme Ativo: LATENCIA ALTA). Onde a rota física passa por (ROTA FÍSICA (ELEMENTOS TX UTILIZADOS)): Não informada Informações Extras / Rascunho: DDMTxBiasCurrentLowAlarm RNAGRJO-RJME04-01-1/1/6 29/01/26 17:26:16 Port 1/1/6-ddm RNAGRJO-RJME04-01 : DDMTxBiasCurrentLowAlarm : Port 1/1/6-ddm : Nokia_NSP_Kafka : NOKIA_NSP : 1 RNACRJO-RJME26-01-1/1/17 A:RNAGRJO-RJME04-01# show port 1/1/6 =============================================================================== Ethernet Interface =============================================================================== Description : CONEXAO AO ACC|RNACRJO-RJME26-01|TE1/1/17|NONE|ACC RJO263| IMP|NONE Interface : 1/1/6 Oper Speed : 10 Gbps Link-level : Ethernet Config Speed : 10 Gbps Admin State : up Oper Duplex : full Oper State : down Config Duplex : N/A Physical Link : No MTU : 9208 Single Fiber Mode : No Min Frame Length : 64 Bytes Loopback Mode : none Loopback SwapMac : No IfIndex : 1292402694 Hold time up : 0 seconds Last State Change : 01/29/2026 10:02:48 Hold time down : 0 seconds Last Cleared Time : N/A DDM Events : Enabled Phys State Chng Cnt: 22 RS-FEC Config Mode : None RS-FEC Oper Mode : None =============================================================================== Transceiver Digital Diagnostic Monitoring (DDM), Internally Calibrated =============================================================================== Value High Alarm High Warn Low Warn Low Alarm ------------------------------------------------------------------------------- Temperature (C) +68.9 +91.0 +89.0 -42.0 -43.0 Supply Voltage (V) 3.32 3.51 3.49 3.12 3.10 Tx Bias Current (mA) 0.0 130.0 120.0 20.0! 15.0! Tx Output Power (dBm) -40.00 4.50 4.00 0.00! -0.50! Rx Optical Power (avg dBm) -11.37 -6.00 -7.00 -24.95 -26.02 =============================================================================== A:RNACRJO-RJME26-01# show port 1/1/17 =============================================================================== Ethernet Interface =============================================================================== Description : CONEXAO AO AGG|RNAGRJO-RJME04-01|TE1/1/6|NONE|ACC RJO263| ACT|NONE Interface : 1/1/17 Oper Speed : 10 Gbps Link-level : Ethernet Config Speed : 10 Gbps Admin State : up Oper Duplex : full Oper State : down Config Duplex : N/A Physical Link : No MTU : 9208 Single Fiber Mode : No Min Frame Length : 64 Bytes Loopback Mode : none Loopback SwapMac : No IfIndex : 1610891400 Hold time up : 5 seconds Last State Change : 01/29/2026 10:02:53 Hold time down : 5 seconds Last Cleared Time : N/A DDM Events : Enabled =============================================================================== Transceiver Digital Diagnostic Monitoring (DDM), Internally Calibrated =============================================================================== Value High Alarm High Warn Low Warn Low Alarm ------------------------------------------------------------------------------- Temperature (C) +61.3 +80.0 +73.0 -3.0 -10.0 Supply Voltage (V) 3.29 3.63 3.46 3.13 2.97 Tx Bias Current (mA) 47.4 120.0 112.0 20.0 17.0 Tx Output Power (dBm) 1.04 6.00 4.00 0.00 -2.00 Rx Optical Power (avg dBm) -40.00 -5.00 -7.00 -24.09! -26.02! ===============================================================================